Standard 9" Paint Roller Frame and 1 Microfiber Roller Cover 3/8" Nap

Instructions：
1.First remove the fur of the roller surface, then cover on the frame.

2.Roll the roller on the net after diping the roller into the dilute coating which be used.

3.To make the roller paint even, dip the roller into the coating, then roll on the net for seconds.

4.First roll the coating as writing “W”, then roll from top to bottom, left and right, make the coating shapely on the wall.

Instructions for Use
Pour a small amount of paint into the deep end of a paint tray.
Push roller into paint, but do not cover axle.
Roll roller backwards and forwards over the ribbed section of the tray to evenly disperse paint over the refill.
Apply paint using long, even strokes in all directions.
Avoid using rapid strokes as this could cause the paint to splatter.
Always work from unpainted surface to painted surface to avoid lines.

Instructions for Clean
Clean roller and tray immediately after use.
Return excess paint to the tin and wipe tray with a cloth or paper towel and clean with warm soapy water. Rinse well.
Remove excess paint from refill by rolling on a newspaper.
Remove refill head and clean thoroughly with warm soapy water. Rinse well in running water until water runs clear.
Shake excess water from roller and hang up to dry naturally, away from direct heat.